We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
String Wound 10 x 4.5 Inch 20 Micron Whole House Water Filter by Tier1
SKU
TIER1-SWC-45-1020
$15.99 List Price $26.99 Save 40%
Availability: In Stock
- Cost effective whole house replacement filter
- Reduces common water contaminants such as sand, silt, rust, and dirt
- Used for a variety of water filtration applications
- Reduces contaminants larger than 20 microns in size
› See more product details
- Cost effective whole house replacement filter
- Reduces common water contaminants such as sand, silt, rust, and dirt
- Used for a variety of water filtration applications
- Reduces contaminants larger than 20 microns in size
The TIER1-SWC-45-1020 is a whole house string wound polypropylene filter that reduces contaminants larger than 20 microns. This filter is effective at reducing water impurities including sand, sediment, silt, rust, and dirt. Useful as a prefilter for a whole house water system or as a single layer of defense for your home's water. Get the water filtration you need with a 10 x 4.5 inch 20-micron string wound polypropylene replacement filter today!
Experience the Tier1 Difference
Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:
- Guaranteed Fit
- Guaranteed Quality
- Guaranteed Price
Reduced Contaminants
The TIER1-SWC-45-1020 reduces the following contaminants:
- Dirt
- Hard Scale
- Rust and Corrosion
- Sand
- Silt
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation